gauge pressure

英 [ɡeɪdʒ ˈpreʃə(r)] 美 [ɡeɪdʒ ˈpreʃər]

表压;计示压力

化学



双语例句

  1. Adjustable spring gauge pressure controlled valve
    压力调节阀压力控制阀
  2. Equipped with the high quality safety valve, cut-off valve, pressure gauge and pressure controller to ensure the safe and reliable running of the boiler.
    配置优质安全阀、截止阀、压力表及压力控制器,确保锅炉安全可靠运行。
  3. Raman Spectra of Carbonate Ions as Pressure Gauge at High Pressure and Room Temperature
    常温高压下碳酸根离子的拉曼谱峰标定压力初探
  4. Adjust balancing valve until pressure differential gauge reads pressure drop required for desired flow rate gpm.
    调整平衡阀直到压差表读出压降符合所要求的流量(加仑/分钟)为止。
  5. At this point the gauge pressure was read. The barometer began to fall.
    气压计的读数开始下降。
  6. The gauge of pressure examination with alarm is equipped to detect deficient pressure and prevent robot from descending.
    备有压力检测开关,气压不足会有警报,防止手臂下降。
  7. Design pressure shall mean the gauge pressure at the top of a completed vessel in its operating position.
    设计压力指完工的容器在操作位置时顶部压力表的压力值。
  8. Machine main instrument is composed of a compressor air pressure gauge, pressure gauge, coolant cooling medium low pressure gauge;
    机台的主要仪表由压缩机空气压力表、冷媒高压表、冷媒低压表组成;
  9. Gauge, pressure, spiral or metal diaphragm-type
    旋转式或金属光阑型压力计
  10. Regarding the inlet pressure, the absolute pressure() or gauge pressure() shall be indicated.
    进口压力还要注明是绝对压力()还是表压力()。
  11. The development of low range and high accuracy strain gauge pressure transducer
    低量程高精度应变式压力传感器研制
  12. Differential pressure remote water gauge should have pressure supplement function to ensure an actual indication of water line in the bubbles under all kinds of working circumstances.
    差压式远传水位表应具有压力补偿功能,以保证各种工况下都能显示汽包中真实水位的变化。
  13. Reid vapor test gauge shows pressure by the height of a column of mercury.
    雷德蒸气压力测试仪由汞柱的高度测量气压。
  14. The pressure tank is provided with a pressure gauge, a pressure switch, a liquid level sensor and an electric heater.
    压力罐装有压力表、压力开关、液位传感器和电加热器。
  15. Strain gauge pressure transducer
    应变(计)式压力传感器
  16. : When dispersed medium pressure was measured with strain gauge pressure transducer, the measurement error must be produced. The cause to result in measurement error was analyzed, and the relation of the measurement error to medium distribution density was found through experiments.
    分析了应变式压力传感器在测量离散介质压力时产生误差的原因,用试验的方法,建立了测量误差与介质分布密度间的相关关系。
  17. Dynamic characteristic compensation of strain gauge pressure transducers and Its Applications
    应变式压力传感器特性补偿和应用
  18. This article describes the basic characteristics of HDL-2176 wave gauge with pressure sensors, and introduces the calculation method of directional wave spectra based on the measured data by underwater pressure sensors.
    本文介绍了HDL&2176底压式测波仪的基本特性,给出了水下压力阵列进行波浪方向谱估计的数据计算方法。
  19. Algorithm Research of the Data Relationship Between Water Level Gauge and Pressure Type Water Gauge
    水尺与压力式水位计数据关系的算法研究
  20. Result of computation of critical bottom blowing flowrate parameter shows that minimum inlet pressure of bottom nozzle is 0.32MPa ( gauge pressure) According to computation of bottom blowing flowrate(?)
    对底吹喷嘴临界供气参数计算表明,在重钢装入量条件下,重钢底吹喷嘴气流最低入口压力为0.32MPa(表压)。
  21. Experimentation and Research for Calibration of Reentry Pressure Dead Weight Piston Gauge by Ultra-high Pressure National ( measurement) Standard
    利用超高压力国家基准对返压活塞式压力计校准的试验研究
  22. Application of spinning rotor gauge in partial pressure measurement
    磁悬浮转子规在分压力测量中的应用
  23. Error analysis on dispersed medium pressure measurement with strain gauge pressure transducer
    应变式压力传感器在离散介质压力测量中误差的试验分析
  24. The affiliation of the electronic balance for mass measurement, vacuum gauge for pressure measurement, and the thermocouple for temperature measurement increase the accuracy of measurement of experimental, and realize the rapid survey of quality, pressure and temperature.
    加入了测量质量的电子天平、测量压强的真空规管以及测量温度的热电偶,并提高了实验装置的测量精度,实现了质量、压强和温度的快速、自动测量。
  25. Based on theory of heat transfer, the relationship between the Pirani gauge structure, pressure and Pirani gauge film resistor has been obtained.
    从基本传热理论出发,得到了皮拉尼薄膜热敏电阻与皮拉尼的关键结构尺寸、气体压力的解析关系。
  26. The leak rate of the seals decreases with increasing the compressive stress and decreasing the gauge pressure.
    所有密封材料的漏气率均随着外加载荷增加而下降,随通气压力的增加而增加。